Tech Support Knowledgebase Browse
 
Tools
Rss Categories

HN7 Navigator - Screen Calibration

Author: Robert Taylor Reference Number: AA-00454 Views: 15153 Created: 2014-06-27 13:22 Last Updated: 2014-06-27 13:44 100 Rating/ 3 Voters

If the screen calibration is out on your HEMA Navigator HN7, that is it registers the screen tap in the incorrect position, it can be rectified by doing the following:

From the main menu of your HEMA Navigator:

Tools button

Tap the Tools button. This will take you to the Settings screen.

Calibration button

Tap Calibration - You will be asked to confirm that you wish to calibrate the screen...

Calibration prompt


Tap OK to confirm, or Cancel if you change your mind.

Calibration process

The calibration screen will be displayed. There will be black cross-hairs in the center of the screen. Tap as closely as you can to the center of the cross-hairs using the stylus (do not use your finger, unless you have very small pointy fingers!)

The cross-hairs will then move to the top-left of the screen

Tap the cross-hairs at top-left. They will then move to a position at lower-left of the screen. Again, tap as closely as you can to the center of the cross-hairs.

Continue this process following the cross-hairs around the screen in an anti-clockwise direction.

Once the cross-hairs at upper-right have been tapped, the Settings screen should be automatically displayed again.

Use the back arrow to return to the main screen.

Your screen is now calibrated.


Please rate articles! It helps us to ensure that you can find relevant information in the Knowledgebase.
You can use the Please rate this article option from the Tools menu at upper-right.
Comments left when rating articles are not replied to, although they are viewed and taken into account.
If you have an issue you need help with, please submit a ticket at Hema Tech Support

Content found in the Knowledgebase is accurate as at time of publication.
Copyright © 2015 Hema Maps Pty Ltd